# /etc/capi.conf - CAPI configuration file # card file proto io irq mem cardnr options # ############################## # ISA/PCI devices # ############################## # These are examples! You have do setup your card correctly. 'P2P' means # 'point-to-point' (leased line) and has nothing to do with PPP. If you # don't have a leased line, then you must not set it. ### AVM B1 (you also have to install the firmware) #b1isa b1.t4 DSS1 0x150 7 - - P2P #b1pci b1.t4 DSS1 - - - - ### AVM C2 (you also have to install the firmware) #c2 c2.bin DSS1 - - - - #c2 - DSS1 - - - - ### AVM C4 (you also have to install the firmware) #c4 c4.bin DSS1 - - - - #c4 - DSS1 - - - - #c4 - DSS1 - - - - P2P #c4 - DSS1 - - - - P2P ### AVM t1 (you also have to install the firmware) #t1isa t1.t4 DSS1 0x340 9 - 0 #t1pci t1.t4 DSS1 - - - - ### AVM FritzCard ISA (A1) #fcclassic - - 0x200 7 - - ### AVM FritzCard PCI #fcpci - - - - - - ### AVM DSL controllers #fcdsl fdslbase.bin - - - - - #fcdsl2 fds2base.bin - - - - - #fcdslsl fdssbase.bin - - - - - ############################## # USB devices # ############################## # If you're using hotplug, you shouldn't configure your devices in this config. # USB devices are detected automatically. If you don't want to use hotplug, then # set CAPI_HOTPLUG_USB="no" in /etc/conf.d/capi and uncomment your card(s) below. ### AVM FRITZCARD!USB #fcusb - - - - - - ### AVM FRITZX!USB #fxusb - - - - - - ### AVM FRITZX!USB OEM #fxusb_CZ - - - - - - ### AVM FRITZCARD!USB v2.0 #fcusb2 fus2base.frm - - - - - ### AVM FRITZCARD!USB v2.1 #fcusb2 fus3base.frm - - - - - ### AVM BlueFRITZ!USB #bfusb - - - - - - ### AVM FRITZDSL!USB (DSL/ISDN) #fcdslusb fdsubase.frm - - - - - ### AVM FRITZDSL!USB SL (DSL only) #fcdslslusb fdlubase.frm - - - - - ############################## # mISDN (experimental) # ############################## #avmfritz - - - - - - #hfcpci - - - - - - #hfcsusb - - - - - - #hfcmulti - - - - - - #sedlfax - - - - - - #w6692pci - - - - - -